Genesis 701-99 Guide d'installation télécharger pdf

For any questions, contact ACP at 800-434-3750.

Visit us on the web at GenesisCeilingPanels.com

revealed edge trim - installation instructions

Figure 1

Figure 2

Figure 3

1. Cut border panels to size.

2. Prepare back of panel to receive trim piece. Clean panel properly by removing

any dirt, oil or dust on the cut panel’s edge.

3. Apply LocTite Super Glue in a thin bead about 1/4" in from the cut edge where

the trim will be attached. (See gure 1)

4. Apply revealed edge trim to cut edge of the border panel as shown in gure 2.

Be sure to align properly with panel’s edge. Trim edge piece at an angle if desired.

(See gure 3) Apply pressure along the entire trim and panel joint to assure proper

adhesive bond.

5. Place border tile into grid and repeat until all border tiles are in place.

Note: Revealed Edge Trim piece is not intended to support weight other than the tile

itself. Insulation, for example, can cause trim piece to become unattached.

Résumé du contenu

Page 1 - Figure 3

For any questions, contact ACP at 800-434-3750.Visit us on the web at GenesisCeilingPanels.comrevealed edge trim - installation instructionsFigure 1Fi

Commentaires sur ces manuels

Pas de commentaire

Genesis 701-99 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Genesis 701-99. Genesis 701-99 Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels